We have a new knowledgebase at kb.egauge.net!

This article can be found HERE.

2-pin CT Plug

Original manufacturer part number: Tyco model 284506-2

Sensor port connector with 2 positions. Accepts one positive and one negative wire. Used to connect CTs and supported sensors to the eGauge, as well as DC voltage to the EG4xxx DC input. Replacement component for eGauge meters.

CTs purchased from eGauge already have 2-pin plug attached to leads.

Hardware included:

1x 2-pin Plug


Do not connect unsupported sensors to the eGauge meter; damage may occur.

Assembly/installation information

The two-pin plug is secured to the ends of a sensor lead for connection to the eGauge. May also be wired to DC output to power and/or take DC voltage measurements to the EG4xxx DC voltage input.